Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to remove module from running-config without reload switch?

Dears,

We just bought a new module  WS-X6816-10GE, and insert into Cat6509 slot 8 by test.

And now we move it back to slot 7, then show module, the new module appears on both slot 7 and 8.

Then I try to reload module, and show module again, It's come back to normal.

Mod Ports Card Type                              Model         

--- ----- -------------------------------------- ------------------

  1  24  CEF720 24 port 1000mb SFP              WS-X6824-SFP   

 

  3  48  CEF720 48 port 10/100/1000mb Ethernet  WS-X6848-GE-TX   

  5    5  Supervisor Engine 2T 10GE w/ CTS (Acti VS-SUP2T-10G     

7  16  CEF720 16 port 10GE                    WS-X6816-10GE     

But through show run commond, I still see the interface TenGigabitEthernet8/1 -16 in it.

And I tried to use "no interface te8/1" to remove the interface from running-config, but it doesn't work.

Is there any way for me to remove it from running-config without reboot switch?

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

How to remove module from running-config without reload switch?

What you should have done is use the module clear-config command before removing the module.  What you can try is to put the module back into slot 8 and then follow the instructions in this link -

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a008086ed2e.shtml#erase_config

Jon

4 REPLIES
New Member

How to remove module from running-config without reload switch?

hi

hehe,First encounter,It does not affect your work on slot 7 .

Proposal ,wr-------copy start-configt  tftp------check it.
  try to :default int g8/1   。

New Member

How to remove module from running-config without reload switch?

Hi, Weijun

That config is stored in RAM, and everyting works fine.

If I backup it to tftp, and modify the config then copy it back to run, the running-config will be "merged" but not overwrited.

I afraid that I need to reboot the switch

Hall of Fame Super Blue

How to remove module from running-config without reload switch?

What you should have done is use the module clear-config command before removing the module.  What you can try is to put the module back into slot 8 and then follow the instructions in this link -

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a008086ed2e.shtml#erase_config

Jon

New Member

How to remove module from running-config without reload switch?

Dear Jon.marshall,

OK, got it,

I'll try it, Thanks a lot.

479
Views
0
Helpful
4
Replies
CreatePlease to create content