04-03-2008 12:14 AM - edited 03-05-2019 10:09 PM
Hi,
I am trying to make a vlan port to truck port,issue is am not not able to remove vlan.
Switch detail-WS-C6509
issue - command to remove "set vlan 172 4/21"
config done for truck
set trunk 4/21 on dot1q 1-1005,1025-4094
out put-
Switch (enable) sh port 4/21
Port Name Status Vlan Duplex Speed Type
----- ------------------ ---------- ---------- ------ ----- ------------
4/21 das4.CTF Fa1/0/1 notconnect 172 full 100 10/100BaseTX
04-03-2008 12:28 AM
You should be able to do this.
1) Set the port back into vlan 1 - "set vlan 1 4/21
2) Then set it as a trunk.
It will show as a trunk when it comes up which it hasn't from your output.
Jon
04-03-2008 12:36 AM
Thanks Jon, it works :)
04-03-2008 12:39 AM
No problem, glad to have helped
Jon
04-03-2008 12:44 AM
Hi Rohit ,
If you want to remove vlan 172 then issue the below command
clear vlan 172
If you want to create trunk port then
This example shows how to set port 5 on module 4 as an 802.1Q trunk port in desirable mode:
Console> (enable) set trunk 4/5 desirable dot1q
Port(s) 4/5 trunk mode set to desirable.
Port(s) 4/5 trunk type set to dot1q.
Console> (enable)
For your knowledge
set trunk
To configure trunk ports and to add VLANs to the allowed VLAN list for existing trunks, use the set trunk command.
set trunk mod/ports {on | off | desirable | auto | nonegotiate} [vlans | none]
[isl | dot1q | dot10 | lane | negotiate]
set trunk all off
Thanks,
Satish
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: