Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to reset a blade in a Cisco 4510

Is there a way (command) short of pulling out a blade, issuing a reload command or unplugging the entire 4510 chassis, to reset a blade within a 4510?

Here is why I'm asking. A co-worker using some Fluke gear claims that the Fluke reports being plugged into blade 9, if indeed its plugged into blade 3. The switch in question is our root switch with hundreds of active ports. He would like to bounce the entire switch and I would like to avoid that. The unit has been running for almost 4 years straight without any issues, a reboot or power loss.

Steve

1 ACCEPTED SOLUTION

Accepted Solutions

Re: How to reset a blade in a Cisco 4510

Correct. It will reload the entire module. It will take about 15-30 seconds for the module to reset.

Mark

3 REPLIES

Re: How to reset a blade in a Cisco 4510

Steve,

Try

hw-module module X reset

Replace X with the module number.

HTH,

Mark

New Member

Re: How to reset a blade in a Cisco 4510

Mark,

So if its blade 3, then I'd issue the following command:

hw-module module 3 reset

I'll assume that it would drop all traffic/ports on that blade until the recycle process completes?

~Steve

Re: How to reset a blade in a Cisco 4510

Correct. It will reload the entire module. It will take about 15-30 seconds for the module to reset.

Mark

5201
Views
0
Helpful
3
Replies