Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to save show tech resualt from Cisco 6006?

Hi!

I would save resualt show tech from my Cisco 6006. As we know the output of the command "show tech" is very lang. How can I save the output from the this command in easy way? Tnaks in advance.

/Sfanayei

4 REPLIES
Hall of Fame Super Blue

Re: How to save show tech resualt from Cisco 6006?

Hi

I usually do it with windows Hyperterm. Log into the switch and

1) IOS - switch# term len 0

Cat0S - switch# set len 0

This will ensure that when you run the command "sh tech..." it will not pause at the end of each screen.

2) In hyperterm along the menu at the top select

Transfer -> Capture Text

You will then be prompted as to where to save the file that will capture the text.

3) Run your command

4) Go back to Transfer -> Capture Text and stop the capture.

HTH

Jon

New Member

Re: How to save show tech resualt from Cisco 6006?

Dear Jon!

It was very useful. I got it. Tanks again

/Sfanayei

Re: How to save show tech resualt from Cisco 6006?

Not sure about catos but with IOS, the terminal length seems to be set by its own when we issue the sh tech-support command. ( I never had to press space :-) )

Narayan

Hall of Fame Super Blue

Re: How to save show tech resualt from Cisco 6006?

Narayan

Thanks again. I use the above primarily for getting a "sh run" so i'm so used to setting the term length. I'm thinking maybe i should retire for the day and let you take over because you are definitely more on the ball this morning :).

About time i rated you

Jon

855
Views
5
Helpful
4
Replies