Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to see the present mac-table aging time/refresh time ?

Hi,

I want to know the present aging time of the below switch. And also the default againg time for a layer 2 2960 switch.

FYI: I'm using PT.

switch2#show mac-address-table ?

  dynamic     dynamic entry type

  interfaces  interface entry type

  static      static entry type

  <cr>

Regards,

Chandu

Regards, Chandu
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

How to see the present mac-table aging time/refresh time ?

Hi,

Try this command on your switches:

sw1#sh mac address-table agi

sw1#sh mac address-table aging-time

Global Aging Time:  300

Vlan    Aging Time

----    ----------

sw1# sw1#sh mac address-table agi
sw1#sh mac address-table aging-time
Global Aging Time:  300
Vlan    Aging Time
----    ----------
sw1#

HTH

4 REPLIES
VIP Super Bronze

How to see the present mac-table aging time/refresh time ?

Hi,

Try this command on your switches:

sw1#sh mac address-table agi

sw1#sh mac address-table aging-time

Global Aging Time:  300

Vlan    Aging Time

----    ----------

sw1# sw1#sh mac address-table agi
sw1#sh mac address-table aging-time
Global Aging Time:  300
Vlan    Aging Time
----    ----------
sw1#

HTH

New Member

How to see the present mac-table aging time/refresh time ?

Thanks for you help. But may be it is not available in PT.

switch1#show mac-address-table aging-time

                               ^

% Invalid input detected at '^' marker.

Regards,

Chandu

Regards, Chandu
VIP Super Bronze

How to see the present mac-table aging time/refresh time ?

Hi,

You are trying:

switch1#show mac-address-table aging-time

try this:

sh mac address-table agi

no dash between mac and address

HTH

New Member

How to see the present mac-table aging time/refresh time ?

Hi Sharifi,

Still same.

switch1#sh mac address-table agi

               ^

% Invalid input detected at '^' marker.

switch1#

Regards,

Chandu

Regards, Chandu
249
Views
0
Helpful
4
Replies