Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to see the size of mls cache on Sup1 CatOS

Hi,

CCO document says,

"If you need to enable IP MLS fast aging time, initially set the value to 128 seconds. If the size of the

MLS cache continues to grow over 32K entries, decrease the setting until the cache size stays below

32K. If the cache continues to grow over 32K entries, decrease the normal IP MLS aging time."

Would like to know is there any show commands that we can used to see the current size of the mls cache ?

Thanks

Eng Wee

1 REPLY
New Member

Re: How to see the size of mls cache on Sup1 CatOS

I saw the below in CCO document, i think this command should show the active mls entries.

Console> (enable) show mls ip

Total Active MLS entries = 0

Total packets switched = 0

IP Multilayer switching enabled

IP Multilayer switching aging time = 256 seconds

IP Multilayer switching fast aging time = 0 seconds, packet threshold = 0

IP Flow mask: Full Flow

Configured flow mask is Destination flow

Active IP MLS entries = 0

Netflow Data Export version: 8

Netflow Data Export disabled

Netflow Data Export port/host is not configured

Total packets exported = 0

262
Views
0
Helpful
1
Replies