Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to set parameters in ROMMON mode in 6500

How to set parameters in ROMMON mode in 6500 to boot from disk1.

acually i am planing to upgrade ios so delete ios from suo bootflash and sqeezed but accidently power down after sqeez.iam having ios in my flash disk,let me know how to configure in ROMMON mode to boot my switch from disk1 while next booting.

1 REPLY
Hall of Fame Super Bronze

Re: How to set parameters in ROMMON mode in 6500

Please refer to this article:

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015bfa1.shtml

HTH,

__

Edison.

Please rate helpful posts

811
Views
0
Helpful
1
Replies
CreatePlease to create content