Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to setup dns over frame-relay

hi:

i have a simple frame-relay setup as shown in the picture below

2011-12-07_001150.jpg

each private address is nat translated. i can visit the server by using its global ip address but i could not use its named address.

all devices are linked ok,

the PC1 side router config are:

ip dhcp pool field_office

network 192.168.1.0 255.255.255.0

default-router 192.168.1.254

dns-server10.10.10.10

!

!

!

!

!

!

!

ip name-server 10.10.10.10

what else should i do to , it seems like pc1 could not resolve dns. shall i place another dns ????

any helps?

best regards.

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Purple

how to setup dns over frame-relay

Hi,

can you contact pc2 by name ?

Regards.

Alain

Don't forget to rate helpful posts.
2 REPLIES
Purple

how to setup dns over frame-relay

Hi,

can you contact pc2 by name ?

Regards.

Alain

Don't forget to rate helpful posts.
New Member

how to setup dns over frame-relay

thanks cadet, i have resoloved the problem, it seems i mis-configured somthing on the NAT.

420
Views
0
Helpful
2
Replies