There is a need to shut down ports on a blade before a change. Instead of shutting each port down, I want to bring the entire module down, perform change and bring the module up after my change. I prefer not to make any configuration changes to individual ports, do not want to use interface range command either. Any help is much appreciated.
Cat 6513 Switch
IOS (tm) c6sup2_rp Software (c6sup2_rp-PK2SV-M), Version 12.1(23)E2, RELEASE SOFTWARE (fc1)
But, I think the Interface-range command with a Shut, no shut, would be safer. Even though it has been rare to happen, I have done this command on a single module and have had the switch loose adjacency with other routers for a second or two. The 6500 reconnected back very quickly, but it was long enough for some of our clustered servers to failover.
I suspect that the rebooting of the module takes a lot of processing time away from the sup engine.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.