Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to span port on WS-C3750G-48TS

I want to monitor a port on this switch (gig 1/0/9) to port 1/0/48. I don't seem to have the option.

WS-C3750G-48TS 12.2(25)SEE C3750-IPBASEK9-M

nj34ex07e2s41b(config)#port ?

load-balance Load Balancing metho

1 ACCEPTED SOLUTION

Accepted Solutions

Re: How to span port on WS-C3750G-48TS

Hi, bedevere

The correct command to use is "monitor session" under configuration mode.

Here is a configuration guide from cisco site.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12225sea/3750scg/swspan.htm

HTH

SSLIN

3 REPLIES

Re: How to span port on WS-C3750G-48TS

Hi, bedevere

The correct command to use is "monitor session" under configuration mode.

Here is a configuration guide from cisco site.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12225sea/3750scg/swspan.htm

HTH

SSLIN

Re: How to span port on WS-C3750G-48TS

Hi,

"monitor session" is the command which you where exactly looking in for.

Cisco Employee

Re: How to span port on WS-C3750G-48TS

Hello,

You are using a wrong command to setup the monitor session on the 3750 switches. The command that you are trying to use was used on earlier 3500XL switches. 3750 switches has different set of commands for port montioring. Do the folloiwng:

Config t

monitor session source interface gig 1/0/9 - 1/0/48 both <-- there is a spance between the port ranges and the - sign

montior session destination interface gig 1/0/x <- X is the port number where montior PC is connected.

Please see the link below for more information and command refrences..

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12235se/scg/swspan.htm

HTH,Please rate if it does.

-amit singh

568
Views
0
Helpful
3
Replies