I need to turn of L3 routing on my 6509 with SUP32 running native IOS 12.2SX Enterprise Services.
I am used to using the command "no ip routing" to accomplish this; however, that command does not appear in global config mode. I checked the Cisco Command Reference Guide for release 12.2.SX; where it is not listed either.
Does anyone know how I can turn off L3 routing in this switch??
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...