Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to upgrade switch flash

Greetings,

I have a Catalyst 3560 that I'm trying to upgrade the flash on. I found a document that outlined the process, which included using the CTRL-Break sequence to change the configuration register (entering into ROMmon mode). The document is specifically geared to cisco routers, so I was wondering if the process is the same for switches. The version of IOS that I'm running is 12.2(35)SE5 and trying to install a version that includes support for BGP. I have the new flash on the switch, but the switch boots to the old flash.

Any suggestions would be appreciated.

Chris

1 REPLY

Re: How to upgrade switch flash

Try

switch(config)#boot system flash:your_ios_image

You can also set it through confreg in rommon, but the above command is easier.

Hope that helps.

129
Views
0
Helpful
1
Replies
CreatePlease to create content