Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to upgrade the ROM: System Bootstrap, Version?

Dear All,

I need to know how to upgrade the system bootstrap image on 6506-E with two rendundant sup32-ge-3b?

Thanks & Regards,

Igor.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: How to upgrade the ROM: System Bootstrap, Version?

Before upgrading Verify the minimum amount of DRAM, flash memory and Boot ROM version necessary for the new software release. Check whether your switch supports the requirements. Refer to Release Notes for Catalyst 6000/6500 Series Switches in order to verify the requirements for the new software image.

Here is the link for Upgrade bootstrap image on 6500 series.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a0080116ff0.shtml#req

1 REPLY
Silver

Re: How to upgrade the ROM: System Bootstrap, Version?

Before upgrading Verify the minimum amount of DRAM, flash memory and Boot ROM version necessary for the new software release. Check whether your switch supports the requirements. Refer to Release Notes for Catalyst 6000/6500 Series Switches in order to verify the requirements for the new software image.

Here is the link for Upgrade bootstrap image on 6500 series.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a0080116ff0.shtml#req

2762
Views
0
Helpful
1
Replies