Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

how to us cb-shape to shape one class without shape other class

my question is acturally two part

1, how to use cb-shape to shape one class without shape other class

2, how do different the the queue method(CBFWQ) is in the in shaper QUEUE (shaping queue) or is CBFWQ in the interface software queue(after shaping).

for example, the questin is

On the WAN edge router, configure the appropriate MQC based

queuing mechanism for the outbound traffic to the WAN (S0/0) so that the following

bandwidth requirements will be met. A strict priority queue with a 168 Kbps

bandwidth guarantee for the class voice is reserved, a minimum bandwidth

guarantee of 30 Kbps is configured for the class interactive, a minimum bandwidth

guarantee of 16 Kbps for class bulk, and the default class is configured for WFQ

with no bandwidth guarantee.

In addition, also limit the bulk traffic class to an average rate of 24 Kbps by

buffering excess traffic(use the IOS default Bc and Be)

1 REPLY
Silver

Re: how to us cb-shape to shape one class without shape other cl

In class based queuing the default is class-default where all the traffic comes.

142
Views
0
Helpful
1
Replies
CreatePlease to create content