Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

how use police QOS for long number of ips with short commands ?

hi all ,

i have a small business router that has simple QOS features.

 

my needs is as below :

i  have network /24 subnet , i need each ip of the 250 ips to get policer with 1.5 Mbps.

 

 

the question is ,

i dont want to make 250 class maps commands line to match each ip and set the police to 1.5 M

 

is there a short command that put police value to each ip inside the class subnet,

10.10.10.1 ==> police 1.5 M

10.10.10.2 ==> police 1.5 M

10.10.10.3 ==> police 1.5 M

..

...

.

10.10.10.250 ==> police 1.5 M

 

is there a simple command tool can help me ??

 

wish to help me 

 

regards

5 REPLIES

Hello.This is not possible on

Hello.

This is not possible on "small business router" (but 6500, 7600). Please share you router model.

Community Member

Hi , not good news from  you

Hi ,

 

not good news from  you !!!

 

i have small busines router usg300G , 

 

does that mean i have to write 250 class map command ????

cryingcryingcrying

 

 

 

regards

Hello.I'm not sure about this

Hello.

I'm not sure about this exact model, but I'm afraid it might be too "small" to run 250 policers.

Community Member

u mean that usg300 cant

u mean that usg300 cant accept 250 class maps on it ??

does that  wt u mean ?

 

enlightened

Silver

Why not police the traffic at

Why not police the traffic at the switch interface level rather than the router?

48
Views
0
Helpful
5
Replies
CreatePlease to create content