Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HP Port teamin and cisco switch

Hi,

I am planning to start using port teaming on a HP DL360 G6 server that is connected to a Cisco Catalyst model  2960. Are there any special configuration that I need to make on the Cisco Catalyst in order for the port teaming on the HP server to work?

Regads,

1 ACCEPTED SOLUTION

Accepted Solutions

Re: HP Port teamin and cisco switch

That depends upon what kind of teaming you gonna use..

1. Fault tolerance >> No configuration required on switch side, use the same port type access/trunk

2. Transmit Load Balance with FT >> no configuration required on switch side, use the same port type access/trunk

3. Switch assisted FT >> Etherchannel using LACP for bundled ports on switch.

For further reading please go through below link for teaming

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c01415139/c01415139.pdf

Hope this helps

Hitesh Vinzoda

Pls rate useful posts

2 REPLIES
Hall of Fame Super Gold

Re: HP Port teamin and cisco switch

EtherChannel.

Re: HP Port teamin and cisco switch

That depends upon what kind of teaming you gonna use..

1. Fault tolerance >> No configuration required on switch side, use the same port type access/trunk

2. Transmit Load Balance with FT >> no configuration required on switch side, use the same port type access/trunk

3. Switch assisted FT >> Etherchannel using LACP for bundled ports on switch.

For further reading please go through below link for teaming

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c01415139/c01415139.pdf

Hope this helps

Hitesh Vinzoda

Pls rate useful posts

696
Views
0
Helpful
2
Replies