I've done a bit of reading about PoE for the 2626-PWR however I'd like a confirmation on a few bits...
1. Does the ProCurve 2626-PWR Supply Power for PoE to the Cisco Devices or would I have to use the Cisco PoE Injector module one for each Cisco AP1242
2. If the Switch 2626-PWR is protected and supplied power/mains by a UPS does that include protecting and supplying power to the Cisco AP1242 Devices for when there is a power failure so there is still WLAN during UPS Supplied Power....
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...