I have two routers that have two seperate t1's. Both routers connect to a MPLS network that talks back to the corporate office. I have HSRP setup on both routers. The routers are connected across the LAN and HSRP works fine. I am only announcing the routes from each router. I.E. 10.110.91.0 /24 is only announce from one router. 10.110.195.0 /24 is only announce from the other router.
When t1's fail at one site HSRP kicks and and fails over like it should. However I cant get to the router that it failed over to from the corporate office until I announce both networks from the one router. So the 10.110.91.0 /24 router is now announcing the 10.110.195.0 /24 network. Can I use the BGP backdoor command on the 10.110.91.254 router to announce the 10.110.195.0/24 network?
Or how can I get the network to be announced when the t1's fail?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...