HSRP config

[jaweed123]

Hi,

How can I add the HSRP config to a VLAN interface option.

Regards

[Amit Singh]

This is how you could do it :

Interface Vlan 10

ip add x.x.x.x y.y.y.y

standby 1 ip x.x.x.x

standby 1 preempt

standby 1 priority 150

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_35_se/configuration/guide/swhsrp.html

HTH,

-amit singh

[bvsnarayana03]

interface Vlan5

ip address x.x.x.x 255.255.252.0

standby priority 60

standby 1 ip y.y.y.y

standby 1 priority 60

standby 1 preempt

x.x.x.x = physical Ip on interface

y.y.y.y = Virtual Ip (used as gateway for hsots on vlan)

Priority = Higher priority switch is active

Preempt = Causes the switch to takeover the active state when its priority is higher than other switch.

[jaweed123]

Thanks ... I will try it should work.

[jaweed123]

Hi Narayan,

The default priority value is 100 and why did you choose the 60 as priority, why not 5 or 100 or 200 or 500 ?

Thanks and Regards

[mahmoodmkl]

Hi

I think the other poster choose the priority 60 in order to make this router as a standby and the other as active.If u leave the priority for default u will not have the control over election of standby and active routers.

Mahmood

[jaweed123]

Thanks Mahmood.