Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HSRP config

Hi,

How can I add the HSRP config to a VLAN interface option.

Regards

6 REPLIES
Cisco Employee

Re: HSRP config

This is how you could do it :

Interface Vlan 10

ip add x.x.x.x y.y.y.y

standby 1 ip x.x.x.x

standby 1 preempt

standby 1 priority 150

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_35_se/configuration/guide/swhsrp.html

HTH,

-amit singh

Re: HSRP config

interface Vlan5

ip address x.x.x.x 255.255.252.0

standby priority 60

standby 1 ip y.y.y.y

standby 1 priority 60

standby 1 preempt

x.x.x.x = physical Ip on interface

y.y.y.y = Virtual Ip (used as gateway for hsots on vlan)

Priority = Higher priority switch is active

Preempt = Causes the switch to takeover the active state when its priority is higher than other switch.

New Member

Re: HSRP config

Thanks ... I will try it should work.

New Member

Re: HSRP config

Hi Narayan,

The default priority value is 100 and why did you choose the 60 as priority, why not 5 or 100 or 200 or 500 ?

Thanks and Regards

Re: HSRP config

Hi

I think the other poster choose the priority 60 in order to make this router as a standby and the other as active.If u leave the priority for default u will not have the control over election of standby and active routers.

Mahmood

New Member

Re: HSRP config

Thanks Mahmood.

155
Views
0
Helpful
6
Replies
CreatePlease to create content