I have two l3 switches A & B. A client router is connected to both these switches. No routing protocol will be used between the router & the two switches. ONly static routes are being used. The client router will have a static route for 172.16.x.x pointing towards the switches & static routes on both the switches towards the router.
However, since the client has asked me to run HSRP between the interfaces on the switches , i'm concerned abt the IP schema to be used. I would be greatly obliged if anybody could suggest on how to run HSRP between the interfaces in the switches connecting the router & also please suggest an IP schema that can be used....
thanks for the response .....but the router has two interfaces one each connecting to both the switches. Moreover i cannot configure two interfaces in the router from the same subnet right?.......PLease help
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.