Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

HSRP Interface Problem

I have confiugred the MHSRP successfully. I am able to provide the redundency and load balancing. But problem is that I am not able to track the Interface connected with WAN.

It is ethernet interface and I mentioned it in HSRP configration, but when it goes down, it is not detected by HSRP.

Below mention is the configuration of HSRP

interface GigabitEthernet0/1

ip address

ip nat inside

ip virtual-reassembly

duplex auto

speed auto

standby 1 ip

standby 1 priority 150

standby 1 preempt

standby 1 track GigabitEthernet0/0

standby 2 ip

standby 2 preempt

standby 2 track GigabitEthernet0/0

Kindly help me out, how to solove this problem. Anyway to configure tracking any other method, if yes then how to configure that method. Why not it is working with HSRP.

Hall of Fame Super Bronze

Re: HSRP Interface Problem

Configure SLA with ICMP Echo to the next-hop by following this document:

Once the SLA is configured, verify the track goes down when the link fails.

Attach the track to the MHSRP configuration along with a decrement value. Currently, I don't see any decrement on the standby 1 track GigabitEthernet0/0 command.

Here is a good example of using track along with HSRP




New Member

Re: HSRP Interface Problem

Thanks for the reply, I made a track for outside interface and it works.

Now i am able to load balance and also getting redundency.

Thank you so much.