Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HSRP interface tracking

I have two cisco routers one of them had two internet connection while the other one had only on internet connection , I need to configure interface tracking for both internet connection so that if the two serial interfaces on the first router goes down the second router becomes the active??how to achieve this??

3 REPLIES

Re: HSRP interface tracking

hello mohammad,

you can just do a normal standby track command on both the serial interfaces

interface ethernet0

ip address 10.1.1.1 255.255.255.0

standby ip 10.1.1.3

standby priority 110

standby track serial0

standby track serial1

Refer to the following URL for more info:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094a91.shtml#intracking

Hope this helps. rate replies if found useful.

Raj

New Member

Re: HSRP interface tracking

I knew the above configs for sure, but I dont want the second router to become the active one when one of the serials on the first router goes down ...only when both interfaces are down the second router becomes the active

New Member

Re: HSRP interface tracking

If the priority of the Standby router us the default value of 100, then the following config will only drop the active router priority below 100 when both serial interfaces are down:

interface ethernet0

ip address 10.1.1.1 255.255.255.0

standby 1 ip 10.1.1.3

standby 1 priority 120

standby 1 preempt

standby 1 track serial0 15

standby 1 track serial1 15

Rgds,

Ian

122
Views
0
Helpful
3
Replies
CreatePlease login to create content