HSRP issue

Anuj Singhi · ‎03-23-2014

I have a server in location A and other server in location B. There is HSRP setup from vlan 11 in location A. When I try to ping a server in location B without any source its working fine, but if i ping the same source from active switch of location A keeping vlan 11 as source I am not able to ping. Please help

paul driver · ‎03-23-2014

Hello Sounds like routing issue and location B hasn't a route back to vlan 11 is vlan 11 being advertised and is location B seeing this prefix? Res Paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

DimaL · ‎03-23-2014

Anuj, try to trace route from B location and as mentioned above, check routing /access lists on the device where trace stops..