You have configured preemtion on both devices. You usually need it on the side with higher priority (7k in this case) can you remove it form the 3560 and test again? Also can you post the output of "sh hsrp 1 detail" from the 7k?
I forgot to say that its when we shutdown the wan onn the nx7k and the floating static route is active we get this problems.......so it might not be a pure hsrp problem?
# sh hsrp detail Ethernetx/x - Group 1 (HSRP-V2) (IPv4) Local state is Active, priority 110 (Cfged 110), may preempt Forwarding threshold(for vPC), lower: 1 upper: 110 Hellotime 5 sec, holdtime 15 sec Next hello sent in 3.132000 sec(s) Virtual IP address is x.x.x.1x (Cfged) Active router is local Standby router is x.x.x.x , priority 90 expires in 12.379000 sec(s) Authentication text "x" Virtual mac address is x (Default MAC) 5 state changes, last state change 1d15h IP redundancy name is hsrp-Ethx/x-1 (default)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.