Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HSRP lab

Hi,

I want to configure HSRP in my lab, I only have 2 x C2620 routers and only have 1 x Ethernet and 2 x WIC on each, is it possible to create an HSPR environment?

If not how would a simple config look?

3 REPLIES
Super Bronze

Re: HSRP lab

I believe so. Just configure HSRP on each router's Ethernet interface. Insure two routers' Ethernet interfaces are connected (directly, hub or switch).

Re: HSRP lab

Hi

As suggested, link the two routers up directly via a crossover cable or via a hub/switch with a straight cable.

An example config for HSRP follows :

Router 1

Ethernet 0/0

ip address 192.168.1.2 255.255.255.0

standby 100 ip 192.168.1.1

standby 100 preempt

Router 2

ip address 192.168.1.3 255.255.255.0

standby 100 ip 192.168.1.1

standby 100 priority 150

standby 100 preempt

Hall of Fame Super Silver

Re: HSRP lab

Hello Andy,

to make a meaningful test an hub or switch is needed so that you can add at least a PC client to the vlan to be able to test what happens when the active router changes.

Hope to help

Giuseppe

267
Views
0
Helpful
3
Replies
CreatePlease login to create content