hello , i have two cisco 2900 with two Ethernet (internal and public) . the Eth0 on both router go to my internal network with Standby configuration . the Eth1 on both router go to two switch , where we are behind two routers xxx1 amd xxx2 . when my primary router1 for a problem switches to standby router2 , the user on router xxx1 or xxx2 lose the link with a internal application
i have only standby configuration on Eth0 (one connected to my internal network) .
I must also configure HSRP on the network to present always the same as the public IP routers xxx1 and xxx2 ???
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...