Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HSRP problem on 6807

Hi Guys

I've a problem on a Cisco 6800 switches with WS-S2T-10G process and ios 15.2(1)SYa - featureset base
My network are describe on attached picture
I've a connectivity problem when I configure HSRP process under Vlan interface. In this configuration, HSRP process it seems correctly, see the next show stnadby all

6807-A#sh standby all
Vlan2 - Group 2
  State is Standby
    1 state change, last state change 2y30w
  Virtual IP address is 192.168.1.1
  Active virtual MAC address is 0000.0c07.ac02
    Local virtual MAC address is 0000.0c07.ac02 (v1 default)
  Hello time 5 sec, hold time 15 sec
    Next hello sent in 4.272 secs
  Preemption enabled
  Active router is 192.168.1.11, priority 110 (expires in 10.524 sec)
  Standby router is local
  Priority 100 (default 100)
  IP redundancy name is "hsrp-Vl2-2" (default)
 
6807-B#sh standby all
Vlan2 - Group 2
  State is Active
    1 state change, last state change 2y30w
  Virtual IP address is 192.168.1.1
  Active virtual MAC address is 0000.0c07.ac02
    Local virtual MAC address is 0000.0c07.ac02 (v1 default)
  Hello time 5 sec, hold time 15 sec
    Next hello sent in 4.432 secs
  Preemption enabled
  Active router is local
  Standby router is 192.168.1.10, priority 100 (expires in 13.376 sec)
  Priority 110 (configured 110)
  IP redundancy name is "hsrp-Vl2-2" (default)


but ping to ip address in the out of network lose many packet.

When I remove HSRP configuration on interface Vlan and i configure VIP like a secondary address on 1 interface, ping don't have any lose!

I've checked hsrp feauture on CCO and HSRP are supported on this release.

Do you have any idea?
Thanks a lot
Bye
Maurizio

73
Views
0
Helpful
0
Replies
CreatePlease login to create content