Hi Guys
I've a problem on a Cisco 6800 switches with WS-S2T-10G process and ios 15.2(1)SYa - featureset base
My network are describe on attached picture
I've a connectivity problem when I configure HSRP process under Vlan interface. In this configuration, HSRP process it seems correctly, see the next show stnadby all
6807-A#sh standby all
Vlan2 - Group 2
State is Standby
1 state change, last state change 2y30w
Virtual IP address is 192.168.1.1
Active virtual MAC address is 0000.0c07.ac02
Local virtual MAC address is 0000.0c07.ac02 (v1 default)
Hello time 5 sec, hold time 15 sec
Next hello sent in 4.272 secs
Preemption enabled
Active router is 192.168.1.11, priority 110 (expires in 10.524 sec)
Standby router is local
Priority 100 (default 100)
IP redundancy name is "hsrp-Vl2-2" (default)
6807-B#sh standby all
Vlan2 - Group 2
State is Active
1 state change, last state change 2y30w
Virtual IP address is 192.168.1.1
Active virtual MAC address is 0000.0c07.ac02
Local virtual MAC address is 0000.0c07.ac02 (v1 default)
Hello time 5 sec, hold time 15 sec
Next hello sent in 4.432 secs
Preemption enabled
Active router is local
Standby router is 192.168.1.10, priority 100 (expires in 13.376 sec)
Priority 110 (configured 110)
IP redundancy name is "hsrp-Vl2-2" (default)
but ping to ip address in the out of network lose many packet.
When I remove HSRP configuration on interface Vlan and i configure VIP like a secondary address on 1 interface, ping don't have any lose!
I've checked hsrp feauture on CCO and HSRP are supported on this release.
Do you have any idea?
Thanks a lot
Bye
Maurizio
