Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HSRP Problems

i have two 4507R working in HSRP, also i has varios cluster, one of then has exchange for mail service, they works with cluster microsoft,(various aplicacion each one with a ip, but i get all service by one IP) the problems occurs whe they make a failover i have to include an static arp ARPA in on of the two 4507r to get works well when they make a failover again i have to erase the static arp and include it in the other 4507 or make a trace to know where i get the cluster.

5 REPLIES
New Member

Re: HSRP Problems

hi recardo..... can u just send me the configs of the vlan that u are using in both 4507R switches....so that i can analize more on this...

New Member

Re: HSRP Problems

i am sending a sh vlan.

Silver

Re: HSRP Problems

If you enabled the multicast in the network, it may capture the HSRP hello packet. Check below link for reference :

http://www.cisco.com/en/US/products/hw/switches/ps679/products_configuration_guide_chapter09186a008007f7ea.html

But the command may not be supported by 4507R.

Try to check below link for the troubleshoot and apply corresponding ACL to the interface. Please check case study 7 and whole article. Or try the BIA command to allocate the MAC address.

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094afd.shtml

Sorry for not tried this and not able to tell the exact solution. Please advise the result when you tested the solutions.

Hope this helps.

New Member

Re: HSRP Problems

4507R Does not support that.

thanks

Silver

Re: HSRP Problems

How about the BIA, can it support ?

179
Views
0
Helpful
5
Replies
CreatePlease login to create content