Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

hsrp standby ip cannot access

One of the standby ip cannot ping or access 

 

hsrp standby ip cannot ping 

interface Vlan22
 ip address 192.168.12.2 255.255.255.0
 standby 0 ip 192.168.12.1
 standby 0 priority 200
 standby 0 preempt
end

interface Vlan22
 ip address 192.168.12.3 255.255.255.0
 standby 0 ip 192.168.12.1
 standby 0 priority 50
 standby 0 preempt
end

It was working suddenly stopped ;)

Everyone's tags (1)
3 REPLIES
Cisco Employee

Okay,Few things to check here

Okay,
Few things to check here as this was working fine and we dont know what software/hardware changes been made. 

1-are you able to Ping the physical IP address of the other ourter?

I.e., to Ping 192.168.12.2 from Device 1?

And to Ping 192.168.12.1 from Device 2?

When you issue sh arp what do you see ==> Here you need to see virtual mac along iwth phycial map.


2- On your router, do you see the entries for the other router physical IP address?

And on R2, do you see the ARP entry for the virtual IP address?

3-
Whats the mac address of virtual Ip it should be 000.0C9f.Fxxxx >>> this should e the one.

4-
Run show standby on both the routes/switch to see the correct status.

5-

did you try failover? i.e Active to Standby if yes did that work?

 

6- 

Is this only with this vlan or all the vlans are having the similar issue?

 

HTH

Inayath

New Member

Rebooted the switch then it

Rebooted the switch then it worked

Cisco Employee

Quick way to solve the issue

Quick way to solve the issue :-)

Mark the thread as solved please so that others with similar issue get benefited.

110
Views
0
Helpful
3
Replies