I have configured HSRP in VLAN 1 on both core switches. Core 1 is active and core 2 is in standby mode. I can see standby,active IP and VIP on both core switches. But from Core 2 (standby) i could not ping VIP,active Ip address.
1.Connection between two core switch is etherchannel. 2.Etherchannal is up and able ping other VLAN's VIP from core2. 3.Did shut and unshut on core2 VLAN # 1 interface , but still not rechable. 4.In core 2, i can learn ARP entry of VIP and active IP 5.From core 1 i can't ping standby IP of VLAN 1. other VLAN's standby IP reachable. 6.Native VLAN is 100. Etherchannel allowed vlan 1 on both side. 7.Switch model is Cisco 3750. IOS - 12.2(55).SE5
Hi Every one I have an similar issue with HSRP version 1 Virtual IP(VIP) address. I am unable to ping VIP. I have configured HSRP between two Cisco 3560 switch Layer 3 VLAN interface and two Cisco ASA 5525 Active /Standby firewall(ASA-FW). However I can ping all physical interface IP address.
The configuration of the devise as follows : Firewall Interface Config ASA-FW# sh runn int gig 0/0 interface GigabitEthernet0/0 description OutSide Sub Interface nameif Outside security-level 0 ip address 220.127.116.11 255.255.255.248 standby 18.104.22.168
HSRP Configuration on Cisco 3560 Switch C3560-AH-EXT#sh runn int vlan 101 interface Vlan101 description FW_OutSide ip address 22.214.171.124 255.255.255.248 standby 101 ip 126.96.36.199 standby 101 priority 120 standby 101 preempt delay minimum 10 Pinging from FW to HSRP VIP Success rate is 0 percent (0/5)
HSRP State on Cisco 3560 SW C3560-AH-EXT#sh standby vlan 101 Vlan101 - Group 101 State is Active 1 state change, last state change 4d18h Virtual IP address is 188.8.131.52 Active virtual MAC address is 0000.0c07.ac65 Local virtual MAC address is 0000.0c07.ac65 (v1 default) Hello time 3 sec, hold time 10 sec Next hello sent in 0.408 secs Preemption enabled, delay min 10 secs Active router is local Standby router is 184.108.40.206, priority 110 (expires in 7.265 sec) Priority 120 (configured 120) IP redundancy name is "hsrp-Vl101-101" (default)
I can see arp entry on FW, I have cheack all subnet mask, Native Vlan mismatch etc.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...