If gig1/1 of Cat6506-1 is directly connected to 7200 router then yes even if port on 7200 on which gig1/1 is connected goes down will bring the lin kon gig1/1 down on 6506-1 an it will trigger the HSRP failover event.
IF 6506 is not directly connected to 7200 and there is some other switch in between then if link goes down on 7200 then 6506 link will still be up and it will not trigger a failover.
One thing to be aware of is that in the config posted even if the gig interface does go down failover will not happen. The high priority is set to 110 and the other is using priority 100. The default for track is to decrement by 10. This would make the priority be 100 if the interface failed. This produces equal priority and failover happens when the other device priority becomes higher than the failing one. When priority is equal there is no failover.
I believe that if they are doing the initial election to determine who should become active and if both have the same priority then they use address. But once they have done the election I do not believe that they continue to use the address. I believe that if you are tracking and if you decrement the priority because of some event but the priorities become equal then the same lead router remains the active lead. For track to change who is the active lead router the priority must become less than the standby router.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.