Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HSRP using 2 MSFCs on Catalyst 6513 single chasis Native IOS ?

Hi!

Can I use HSRP on a single chasis 6513 with 2 MSFC cards and Native IOS? if so, how can I switch from one MSFC to another?

Some time ago I used the command "session

slot #", but I did it on a hybrid (ios & catos) 6513. Is this still possible using Native IOS?

Thanks in advance!!

Regards,

Sergio.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: HSRP using 2 MSFCs on Catalyst 6513 single chasis Native IOS

No. With Native IOS both the Supervisor & the MSFC operate in Active/Standby mode using a single IOS image.

Andy

1 REPLY

Re: HSRP using 2 MSFCs on Catalyst 6513 single chasis Native IOS

No. With Native IOS both the Supervisor & the MSFC operate in Active/Standby mode using a single IOS image.

Andy

125
Views
0
Helpful
1
Replies