Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

HSRP with no L2 connectivity

Is this possible via pseudowire?

Alternatively two sites, both with internet connectivity - one deemed to be primary link the other failover. Sites also connected at L3 via a Service providers MPLS network.

What mechanism do I use to tell the site's network to use the failover link when the primary link fails?

3 REPLIES
New Member

Re: HSRP with no L2 connectivity

You can use weighted statics

New Member

Re: HSRP with no L2 connectivity

As I pressed the submit button I recalled that as a possible solution.

However, I think I may have a requirement for a single published IP gateway address. Not sure how this would work though..

New Member

Re: HSRP with no L2 connectivity

What about BGP/EIGRP/IGRP and weighted static of the backup of 180

So when the primary link fails the protocol will drop and see the satic of 180 as the best route(backup router)

124
Views
0
Helpful
3
Replies