Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

HSRP

Hi all

I want to setup hsrp on my dist switches

should I put the timers to

subseconds

for example:

standby 1 timers msec 200 msec 1000 ?

Also, can I use the same standyby group for each vlan

so vlan 1

standby 1 ip x.x.x.x

vlan 2

standby 1 ip x.x.x.x etc ?

cheers

Carl

3 REPLIES
Hall of Fame Super Silver

Re: HSRP

Hello Carl,

a) yes

b) yes and it is advantageous for scalability in some L3 switches you can use up to 16 different HSRP groups so reusing the same groups is a key aspect for scalability

Hope to help

Giuseppe

Community Member

Re: HSRP

what would happen if I put the preempt command on both, but did not change the priority level on either, which would be active ?

Re: HSRP

If both switches are booted at the same moment:

In the case of an equal priority, the router with the highest IP address for the respective group is elected as active. Furthermore, if there are more than two routers in the group, the second highest IP address determines the standby router and the other router/routers are in the listen state.

111
Views
0
Helpful
3
Replies
CreatePlease to create content