I'm configuring the AP801 integrated into ISR 860W. Via CLI everything's fine, but if i connect thru http, the browser opens the page, i'm asked for credentials, and then i land to a blank page where ther's just an "Enter" button that does nothing when pressed (screenshot attached).
I tried with IE6, IE8, FF3.5 and they all show the same behaviour. Any hints?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...