Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HW-MODULE UPLINK SELECT command missing on 4507R+E Sup7-E IOS 15.1(2) SG4

We have a 4507R+E with dual Sup7-E's running IOS 15.1(2) SG4.  The license level is LANBase.  I am creating the initial configurations for the switch but cannot change the uplink state of the SFP ports on the supervisors.  I tried to run the command HW-MODULE UPLINK SELECT but it is not present.  These are the only option available under HW-MODULE.

switch(config)#hw-module ?
  module  Specify a linecard slot for the hw-module command
  slot    Specify a linecard slot for the hw-module command
  system  Specify the system parameter

 

Is this a license restriction?

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

On a 4507R+E, "hw-module

On a 4507R+E, "hw-module uplink select all" is enabled by default, however, because you've got redundant Sup card, the uplink ports 3 & 4 are disabled permanently. 

 

This is because the backplane speed of the chassis is 48 Gbps.  So you can only use up to four (4) 10 Gbps interfaces.

3 REPLIES
Hall of Fame Super Gold

On a 4507R+E, "hw-module

On a 4507R+E, "hw-module uplink select all" is enabled by default, however, because you've got redundant Sup card, the uplink ports 3 & 4 are disabled permanently. 

 

This is because the backplane speed of the chassis is 48 Gbps.  So you can only use up to four (4) 10 Gbps interfaces.

Cisco Employee

LEO--PM

LEO--PM

Hall of Fame Super Gold

Got it.  :)

Got it.  :)

486
Views
0
Helpful
3
Replies
CreatePlease login to create content