Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

HWIC-2811 router

hi,

i am using 4 ports HWIC in 2811 router for LAN interface. All ports are layer 2 ports unable to assign ip address. I am using advance security IOS 12.4(5)trying to create vlan. but unable to enter vlan in data base, when trying to map one of port of HWIC to that port its giving error vlan not in database...i am unable to find any command for this supported in this IOS.

i want to use thses ports as layer-III ports. Any idea? I'll appriciate your response.

  • LAN Switching and Routing
2 REPLIES

Re: HWIC-2811 router

Aziz,

If you are talking of the HWIC-4ESW module, then as per the data sheet, these ports cannot be used as a routed port. However you can definitely go to the VLAN database mode and configure VLANS and SVIS

Have a look at this link

http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a00804554c7.html#wp1043332

HTH

Narayan

Purple

Re: HWIC-2811 router

They cannot be used as a routed port per se but the port should still be routable, just create a layer 3 SVI for the vlan and then put the interface into that vlan .

router#vlan database -->hit enter

vlan 10

exit

interface vlan 10

ip address 192.168.10.1 255.255.255.0

interface f4/0

switchport access vlan 10

107
Views
5
Helpful
2
Replies
This widget could not be displayed.