Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

HWIC-4ESW in 2801, can't get working....

I have placed a hwic-4esw in my 2801.

I've created a subinterface and assigned that switchport to that vlan. I have then connected it to my 3750. I can see the link in cdp. I can even see the mac of the hwic-4esw in my 3750 mac table, but nothing more than that. I've attached the configs.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: HWIC-4ESW in 2801, can't get working....

no interface FastEthernet0/1.75

interface Vlan 75

description DMZ

ip address 10.10.75.22 255.255.255.0

no ip redirects

ip unreachables

no ip proxy-arp

no cdp enable

3 REPLIES
Community Member

Re: HWIC-4ESW in 2801, can't get working....

hi,

if You want connect DMZ to port on HWIC-4ESW You must setup interface VLAN 75 with IP ADDRESS. Interface FastEthernet 0/1.75 is part of trunk on FastEthernet 0/1?

regards

romek

Re: HWIC-4ESW in 2801, can't get working....

no interface FastEthernet0/1.75

interface Vlan 75

description DMZ

ip address 10.10.75.22 255.255.255.0

no ip redirects

ip unreachables

no ip proxy-arp

no cdp enable

Purple

Re: HWIC-4ESW in 2801, can't get working....

Get rid of the subinterface and create the following . Put that switchport into vlan 75.

Sorry didn't see the previous post which said the same thing!!

interface vlan 75

description DMZ

encapsulation dot1Q 75

ip address 10.10.75.22 255.255.255.0

no ip redirects

no ip unreachables

no ip proxy-arp

no cdp enable

295
Views
10
Helpful
3
Replies
CreatePlease to create content