05-27-2010 02:40 PM - edited 03-06-2019 11:18 AM
does anyone know an easy way i can check if i am running my Sup32s in Hybrid or Native mode? i understand the diference from an architecture standpoint, but how do i tell what mode they are in?
Thanks in advance for your help!
05-27-2010 03:03 PM
Jarrod
Does your running config have
"switchport access vlan xx" commands under the interface = native
or
set vlan
Native = L2 and L3 is configured from one place
Hybrid = L2 configured from supervisor with "set" commands, L3 configured from MSFC.
Jon
05-27-2010 03:05 PM
Hello Jarrod,
native mode has only one telnet/SSH session
sh ip interface brief
is supported
CatOS allows to telnet/SSH to layer2 supervisor and to routing engine (MSFC) as distinct heads
from supervisor you can access MSFC with session N, where N is a number like 15
sh port
is supported
when in enable mode prompt becomes switch(enable)>
show module can tell you all this at once looking at SW column
Hope to help
Giuseppe
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: