Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I am getting the following error messages:

I am getting the following error messages:

May 29 15:31:42.404 utc: %SFF8472-5-THRESHOLD_VIOLATION: Gi1/1: Rx power high warning; Operating value:  -2.0 dBm, Threshold value:  -3.0 dBm.

May 29 15:41:42.974 utc: %SFF8472-5-THRESHOLD_VIOLATION: Gi1/1: Rx power high warning; Operating value:  -2.0 dBm, Threshold value:  -3.0 dBm.

 

What is the solution?

2 REPLIES

I'm not familiar with this

I'm not familiar with this error, check this:

 

http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/gigabit-ethernet-gbic-sfp-modules/product_data_sheet0900aecd8033f885.pdf

Ref: http://www.boards.ie/vbulletin/showthread.php?p=88701476

 

Green

Hi, From the error decoder

Hi,

 

From the error decoder

 

Showing 1-3 of 3 results Page: 
1. %SFF8472-5-THRESHOLD_VIOLATION: [char]: [char]; Operating value: [char]

There was a threshold violation as specified in the message.

Recommended Action: Contact your technical support representative.

Related documents- No specific documents apply to this error message. 

2. %SFF8472-5-THRESHOLD_VIOLATION: [char]: [char]; Operating value: [char]

There has been a threshold violation as specified in the message.

Recommended Action: Make sure that the port is active. If port does not need to be active, then transceiver ought to be removed. If port should be active, but is not, then make sure that the connection is appropriate. Sometimes, removing and reinserting transceiver might help. For all other issues, please contact technical support.

Related documents- No specific documents apply to this error message. 

3. %SFF8472-5-THRESHOLD_VIOLATION: [char]: [char]; Operating value: [char], Threshold value: [char].

The specified port is not connected, or it is connected to a damaged fiber optic cable.

Recommended Action: If the message relates to an enabled but unconnected DOM transceiver, shut the port to stop the alarm messages. If the alarm persists, or relates to an enabled and connected transceiver, contact your Cisco technical support representative.

Related documents- No specific documents apply to this error message. 

 

Hope this helps

Regards

Alex

Regards, Alex. Please rate useful posts.
93
Views
0
Helpful
2
Replies