I have several vlan and cat 3750 with SVI-interfaces in my network. There is DHCP-server in one of the VLAN and cat3750 uses ip-helper on every SVI to forward DHCP-packets from PC to DHCP-server. When I connect windows-host it get ip-address from DHCP-server and it's all right. When I assign a static IP-address to this host from the same subnet as IP from appropriate SVI it works fine and I don't have any problem. If I try to assign to host a static IP address from another subnet then IP from SVI host get APPIPA address from range 169.254.0.0. I can't assign any static IP from any subnet which differs on subnet from appropriate SVI-interface. Why does it happen?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...