I cannot connect by console port to Cisco Catalyst 3750 using ethernet to USB.
Hello. I have one Cisco Catalyst 3750 switch, and two 2950 switches. I am trying to reset their settings using a console cable with a trendnet Ethernet to USB adapter. When I try loading hyperterm or putty on com3 there is no signal. I have the communication port setting on com3. I don't know what the old settings are, and they can be reset. I get connectivity lights when plugging the cable into the switch ports. What am I missing?
Are you definitely using the correct COM Port number? On Windows7 Right Click My Computer > Manage Then select Device Manager and expanPorts (COM & LPT)d in my case is shows Prolific USB-to-Serial Comm Port (COM5).
Once you have the right COM Port number just use the default settings in Putty. You may find the COM Port is locked up which will require a reboot.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...