Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

i get a error message while adding a line in Cisco ASA

Hi,

i get error message "ERROR: access-list has protocol or port" while adding a line nat (inside) 0 access-list zeronat0" can some one tell me what exactly the problem is.

Cisco ASA 5510 - asa704-k8.bin

3 REPLIES

Re: i get a error message while adding a line in Cisco ASA

Hi,

Have you checked the acl zeronat0...

-VJ

Re: i get a error message while adding a line in Cisco ASA

what exactly it mean? this message i get in my standby ASA, where as in my main ASA i never get this message when adding, also in main ASA, when i type "write standby" all lines gets synced,except the one which i was trying.

Re: i get a error message while adding a line in Cisco ASA

removing the redundant post.

138
Views
0
Helpful
3
Replies
CreatePlease login to create content