Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

I have a question about Error message on the WS-X6248-RJ-45

Hi, there

What does it mean by below Err Msg ?

and  What is the Bus Asic ?

Do you happend to have the architecture of WS-X6248-RJ-45 ?

ㅁ Verson     : cat6000-sup2.6-4-13.bin

ㅁ supervisor : WS-X6K-SUP2-2GE

ㅁ Chassis    : C6509

ㅁ Err Msg   : %SYS-3-SYS_LCPERR3:Module 9: Bus Asic #0 out of sync error: Module requires attention - troubleshoot or contact TAC for assista.

6 REPLIES
Cisco Employee

Re: I have a question about Error message on the WS-X6248-RJ-45

Hi,

The bus ASIC is used to send packets for lookup. The port ASIC handles transmission and reception for several physical interfaces.

Please try one of the following workaround and if it doesn't make the message disappear, open an SR for RMA request:

1- Try to reset the LC

2- Try to reseat the LC

HTH

Laurent.

Community Member

Re: I have a question about Error message on the WS-X6248-RJ-45

Hi, Laurent Aubert

Is Port ASIC the Pinnacle ASIC or Coil ASIC ?

Cisco Employee

Re: I have a question about Error message on the WS-X6248-RJ-45

Hi,

It's the COIL ASIC.

Laurent.

Community Member

Re: I have a question about Error message on the WS-X6248-RJ-45

Hi, Laurent.

I appreciate your help.

By the way,

There are 4 Coil Asics on the WS-X6248-RJ-45.

If Port Asic is Coil Asic, a group of ports should not work.

However, All the user who connect to the ws-x6248-rj-45 didn't work.

Cisco Employee

Re: I have a question about Error message on the WS-X6248-RJ-45

The issue is on the bus ASIC shared by all Port ASIC's.

Laurent.

Hall of Fame Super Gold

Re: I have a question about Error message on the WS-X6248-RJ-45

This error means that you need to contact Cisco TAC and organize for the blade in slot 9 to be RMA-ed.

ASIC stands for Applications Specific Integrated Circuit.

909
Views
0
Helpful
6
Replies
CreatePlease to create content