Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

I have some question about configuring 802.3ad...

Hi, I just have simple question about configuring 802.3ad

I am planning to configure port load-balancing by lacp. And I am newbie so I always use  CISCO configuration guide.

I found some different thing that are between PAgP and LACP. It is about port-priority.

PAgP port-priority can configure from 0  to 255 however lacp has <1 - 65535> priority.

So I tried LACP on my switch using priority 0. but it didn't make any error message or any alert.

So I'm really curious that cisco configuration guide has documentated a fault information or I have wrong idea...

Somebody answer me..

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_55_se/configuration/guide/swethchl.html#wp1275688

enter Ctrl + F and input lacp port-priority

194
Views
0
Helpful
0
Replies