Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

I need an advice in full connectivity between IPV4-IPV6 network

Hi , 

 

i have a network topology as attached.

 

 

as you see it has both ipv4 & ipv6

 

i just need an ideas here about how let all pcs (ipv4 & ipv6) to talk together based on the topology attached.

 

2 REPLIES

Hello Ahmed,You can use BGP

Hello Ahmed,

You can use BGP with address-family ipv4 to provide routing for ipv4 and address-family ipv6 for ipv6.

This means between your router's you will have 2 BGP peerings, one for v4 one for v6.

If you use the ipv4 address for bgp address-family ipv6, you will have to apply a route-map on neighbor to change the next hop address to the relevant ipv6 interface address.

hth

Bilal

CCIE #45032

Please rate useful posts & remember to mark any solved questions as answered. Thank you.
New Member

thanks but im looking for

thanks but im looking for simple answer like full dual stack or by using NAT protocol.

 

regards

68
Views
5
Helpful
2
Replies
CreatePlease to create content