I need to allow access to a company printer from unsecured publi
If the current access restriction is on the router then it would seem logical that you would make changes on the router to allow access to the printer from the wireless network. The easy thing would be to allow access from wireless to IP address 192.168.0.10. If you wanted to be more precise you could identify the ports being used to access the printer and permit access only to those ports on that address.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...