Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

I need to set my manangement IP address and gateway on a 4500

In mucking around with my 4500 I accidently deleted the ip address that I use to get into it with telnet and CNA. I have a console cable hooked up to and I'm in that way but the commands I got off the internet did not work. Those commands were set interface sc0 10.x.x.x/xx and set interface me1 10.x.x.x/xx. It didn't like interface and I notices when I did a set ? it looked like it wasn't what I wanted.

How do I get back in?

  • LAN Switching and Routing
1 ACCEPTED SOLUTION

Accepted Solutions

Re: I need to set my manangement IP address and gateway on a 450

Do you still have vlan 1? If so, you should be able to do something like:

int vlan 1

ip address

**** Edit ****

With all of the set commands it looks like it's running CatOS. If that's the case, disregard what I said earlier. I have no experience with CatOS.

HTH, John *** Please rate all useful posts ***
6 REPLIES

Re: I need to set my manangement IP address and gateway on a 450

Do you still have vlan 1? If so, you should be able to do something like:

int vlan 1

ip address

**** Edit ****

With all of the set commands it looks like it's running CatOS. If that's the case, disregard what I said earlier. I have no experience with CatOS.

HTH, John *** Please rate all useful posts ***
Silver

Re: I need to set my manangement IP address and gateway on a 450

Hi William,

Could you try to add  the managment vlan number after sc0...      => Of course in enable mode : switch (enable)

set interface sc0 -->vlan_ID<--- 10.X.X.X/255.X.X.X  Y.Y.Y.Y

I suppose also your default route has not been affected by the accidental modification. But if needed :

set ip route 0.0.0.0/0.0.0.0         Z.Z.Z.Z 

Best regards.

Karim

New Member

I need to set my manangement IP address and gateway on a 4500

What is that Y..Y.Y.Y aftter the first part? I sitll have vlan 1 so that is a good thing and nobody is complaining.

Silver

I need to set my manangement IP address and gateway on a 4500

Hi William,

It is corresponding to the Broadcast address of sc0 interface subnet.

Example at => http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008010e9ca.shtml#topic1

(Then show interface to validate the status of this interface)

Regards;
Karim

New Member

Re: I need to set my manangement IP address and gateway on a 450

Yes the int vlan 1 etc. worked. Thanks very much for that. My worry and I didn't think I did was to hose the whole switch. I as creating an etherchannel and the last part was vlan1 no ip address, as soon as hit enter I thought I'll bet I lost my connection to it. Fortunatley I was in the same building and hooked a laptop up to the switch.

thanks again

Re: I need to set my manangement IP address and gateway on a 450

Glad to hear it William...thanks for the rating!

HTH, John *** Please rate all useful posts ***
290
Views
0
Helpful
6
Replies
This widget could not be displayed.